My Account
If you are already registered, please log in.
Create your account and enjoy a new shopping experience.
Create A New Account
This is a new height control solenoid restrictor valve assembly, often referred to as the roll restrictor valve.
There are two on each car - one is high pressure and one is low pressure.
It is very common for these valves to become blocked, especially if the fluid in the hydraulic system has been contaminated as the rubber seal tend to break up and are often found to cause this valve to become blocked.
Core Charge $150
1968-1980 All Models
**Note: This has 3 ports, the early valve has 4 ports and that part number is UR14328
This is a reconditioned rear height control solenoid. All of our reconditioned hydraulic braking and suspension units for the Shadow and T Type are professionally reconditioned in-house. They are...
This kit includes the o rings, boots and clips required when rebuilding the height control solenoid. In addition, it also includes the valve cone, which becomes distorted over time and should...
This is the right hand rear height control valve. Each valve has been fully stripped, cleaned and inspected for damage (in particular the housing, piston and valve). The unit is rebuilt and...
