Cylinder Head

This is the washer for the crankcase / cylinder head. 1960-1965 Silver Cloud II,III and Bentley S2,3 Phantom V models 1966-1980  Silver Shadow, T-series, Shadow II, T-2, Silver Wraith II 1981-1998...

This is the standard size seat inside the cylinder head for the inlet valve.

All cars from 1959 through 1997 were originally fitted with these cork rocker cover gaskets.  From 1998 all V8 engine models were fitted with rubber gaskets (UV11305PAP) which can be retro-fitted to...

This is the valley pan gasket also known as the tappet cover gasket for V8 models. 1959-1965 Silver Cloud II,III & S-2,3 1959-1968 Phantom V 

This is a factory original new old stock engine valley pan cover also known as the lifter pan cover. Note: This photo was taken with the protective Cosmoline paper put on by the factory. 1959-1965...

This Ring is for Sealing the Cylinder Liner on all V8 models. All V8 Engine models from 1959-2002

This is a Plain Washer found in many areas on the cars. Supersession: CS6503Z, K4404Z, X4404Z, X4404ZP 1946-1955 It is the washer for the exhaust manifold stud (KB359Z). There is one washer per stud...

This washer is found all over the cars from 1955-1997 Front Door Hinge Transmission Gear Change Volute Casing Thermostat

This is the sealing o ring for the water connector UD4791 on the B bank cylinder head. 1959-1965 Cloud II,III & S2,3 1959-1968 Phantom V

This is the intake valve guide inlet (standard). 1959-1965 Cloud II,III & S2,3 & Phantom V 1966-1977 Shadow, T Saloon & Shadow, T Coachbuilt (VIN SRH1002-SRE26700)

Manifold Gasket to Cylinder Head Gasket. Note:  4 Per Car  (Sold Separately)  1959-1965 Rolls-Royce Silver Cloud II,III & Bentley S-2,3, 1959-1965 Phantom V

This is the rocker cover ferrule. Note: 6 Required per Engine (Sold Each)  1959-1965 Silver Cloud II,III, Phantom V & S2,3  All V8 Models  

Exhaust manifold to cylinder head stud.  8 required per manifold (Sold Each) 1959-1965 V8 Models Silver Cloud II, III & S-2,3, PV's, Continental's

This is a good used exhaust manifold stud.  These have been cleaned and checked. Note: 8 Per Car (Sold Each)  1959-1965 V8 Silver Cloud II,III and S-2,3, Phantom V

This is the nut for the exhaust manifold stud UE3831. There are 8 nuts per manifold. Please be aware that some cars are fitted with a heatshield above the right hand manifold. These cars have 6 nuts...

This is the cylinder head gasket for all models from 1960 onwards. 1960-1965 Silver Cloud II, III and S-2,3, Phantom V 1966-1980 All Models 1981-1998 All Models  Arnage Le

This is the stud for the crankcase to cylinder head block to head. 4 Per car (Sold Each) 1959-1965 Silver Cloud II,III, S-2,3, & Phantom V

This is the Cover to the Distributor Drive Crankcase. 1959-1965 Cloud II,III & S2,3 1959-1968 Phantom V 1966-1980 All Models

This .250UNF x .625in long Bolt fits: Note: Contact us for direct diagram fitting to the areas listed below 1955-1965  Power Steering Cylinder Bracket, A/C Controls & Demister Ducting Blower, A Bank...

Bolt .250 UNF x .375" long fits: Air intake filter, Cooling fan (electric), front bumper, crankshaft & main bearings, starter ring gear & torus Please Contact our Sales Department for Diagram...

This is an aluminum washer, commonly used in the engine, fuel system, and steering. 1945-1955 Silver Wraith, Mk-6, R-type, Sliver Dawn  1959-1965 Silver Cloud II,III, S-2,3, Continental, & Phantom...

This is a good used .250 x 1.25 inch bolt.  This bolt can be found in all year models from 1945-1998 in many, many different areas in each year model category.  This photo is for reference only...