VIN 20001 to 31500 (Except Turbo R)

Washer for the rear hub & anti-lock braking system 1987-2002 All Models (from VIN 20001 onward)

This is the right hand rear brake rotor.  1987-1998 From VIN 20001 onwards   

This is an outer rear wheel bearing. Cup and Cone are sold together. 1966-1980  Silver Shadow, T-series, Shadow II, T-2, Silver Wraith II 1980-2003  Silver Spirit, Silver Spur, Mulsanne, Turbo R Pre Arnage  

This is the inner rear wheel bearing assembly (cup and cone) for all models from 1966 onwards. 1966-1980  All Models 1980-2000  All Models

This is the rear hub seal.  1987-1989 (VIN 20000-28000) Usually will need the following when replacing the rear rotor SPC3405, UG10045, UG11161, UG10154 (1 each per hub)

This is the Hub o ring for the rear hub. 1966-1980 Silver Shadow I,II,III, T-series, Silver Wraith II 1981-1998 Silver Spirit, Silver Spur, Mulsanne, Turbo R Pre Arnage  

This is the felt needed when replacing the rear hubs.  1966-1980 Silver Shadow I,II,III, T-series, Silver Wraith II 1981-1998 Silver Spirit, Silver Spur, Mulsanne, Turbo R Pre Arnage  

This is the rear hub adjusting nut.  Usually required when changing out brake rotors. When adding the nut you may need to replace O ring (UG11161) 1966-1980 VIN 1001-41686 1980-1998 From VIN 1001 onwards

This is the left hand rear brake rotor. 1987-1998 (From Vin 20001 onwards)

Circlip Rear Hub & Driveshaft Hub 1982-2000 (all models from VIN 04233 onward)

Socket headed 6mm screw for the rear hub & anti-lock braking system. 1987-2002 All Models (from VIN 20001 onward)

This is the main torque tightened nut for the rear hub assembly. It is fitted to all rear hubs which contain a woodruff key fitting in the stub axle. This nut must be tightened down to between 500 & 525 lb/feet on all cars after VIN 1916 (1937 on...