Front Suspension

This upper bearing pin is for the early Series 1 cars with non-compliant front suspension that have four pins and bushes which mount the upper lever (wishbone) arms to the front sub-frame. 1966-1972 (VIN 1001-13484)

This a USED shock tower cover in "aluminum" not pressed steel.  These are hard to find in good re-usable condition and are not available any longer. You may also need UR72172 gasket for the cover.   1971-1980 VIN 11500...

This is a plastic cap for the front shock suspension. This original part number was SPC1293 but has been superseded to SPC3734. 1966-1980  Silver Shadow, T-series, Shadow II, T-2, Silver Wraith II 1981-1998 Silver Spirit, Sliver Spur, Mulsanne,...

These are the Metalastic washers for the front suspension bearing pins. (UR13211, UR10489 and UR10490) 1966-1980 Rolls-Royce Silver Shadow I, II & Bentley T1, T2 1980-1982 Silver Spirit, Silver Spur, Mulsanne, Turbo R

The camber bush is pressed into the top wishbone arm on all compliant front suspension cars where the arm mounts to the subframe. Note:  2 per car  (Sold Each)  1972-1980 VIN 13485-41686 1980-1998 From VIN 01001 onwards

This is the lower triangle lever front suspension rear left hand. 1970-1980 Shadow, Shadow II, Corniche, Camargue, Wraith II, T

This is the seat that the front road spring sits in. Originally these were canvas but they are now plastic. They stop the metal spring from grinding against the metal spring support.On the MkVI, R type and Silver Dawn models there is a seat above and...

This is the lower rear bearing pin that fits between the rear of the lower wishbone arm and the back of the front subframe. There are two per car and as they are located below the bell housing so they tend to suffer from oil ingress. When replacing this...

This is the lower front bearing pin that fits between the front of the lower wishbone arm and the front of the front subframe. Note: 2 Per Car (Sold Each) 1966-1980  Silver Shadow, T-series, Shadow II, T-2, Silver Wraith II  (VIN...

This is a .5in shim that controls the adjusting height on the front spring. 1966-1980 Silver Shadow, T-series, Shadow II, T-2, Silver Wraith II 1981-1998 Silver Spirit, Silver Spur, Mulsanne, Turbo R, Pre Arnage, Azure

This is the sleeve that sits around the center of the front shock absorber body. The spring support UR12899 sits onto this sleeve. Original part# was UR12899. 1966-1980 Silver Shadow, T-series, Shadow II, T-2, Silver Wraith II

The compliant mount is the rubber mount that fits where the top wishbone mounts to the back of the front subframe. 2 required per car (Sold Separately)  1972-1980 VIN 13485-41686 1980-1998 VIN 1001 onward