Rear Calipers (Later cars with No Master Cylinder)

This is the right hand rear caliper for all cars from VIN 22118 which are not fitted with a master cylinder. Fits: 1975-1980  (VIN 22118-41686)  

This is one of the flexible rubber brake hoses for the right hand rear caliper. It runs along the rear trailing arm and is the outer (longer) hose of the two. The inner hose is CD6247. There are also two of these hoses from the rat-trap (master...

This is the small spring which retains the handbrake pads.  Note: 1 Per Caliper (Sold Each) 1966-1980 Silver Shadow I,II,III, T-series, Silver Wraith II 1981-1998 Silver Spirit, Silver Spur, Mulsanne, Turbo R Pre Arnage 

This is the flexible rubber brake hose for the right hand rear caliper.  this one runs along the rear trailing arm and is the inner (shorter) hose of the two.  The outer hose is CD6248.  These two hoses have been known to swell and block...

This is a complete set of seals to reseal both rear calipers.  This kit fits models WITHOUT a master cylinder.   If you are splitting the calipers in half, then you will also need to order two gallery seals (part number GALLERYRR363) per...

This is the small rear caliper piston for 1966-1998 All Models  On the early Silver Shadow and Bentley T models (up to VIN 22117) each rear caliper had two small pistons and two large pistons (CD6283).On the later Silver Shadows and...

This is the R clip required to hold the brake pad CD6722 & CD6396 retaining pin CD4075 in place in the front caliper and all rear calipers 1973 after. 1966-1980 All models 1981-1998 All models

This is one of the flexible rubber brake hoses for the left hand rear caliper. It runs along the rear trailing arm and is the inner (shorter) hose of the two. The outer hose is CD6244. These hoses have a tendency to swell and block internally and are...

This is the flexible rubber brake hose for the left hand rear caliper.  This hose runs along the rear trailing arm and is the outer (longer) hose of the two.  The inner hose is CD6243.  These two hoses have been known to swell and block...

This is the left hand rear caliper for all cars from VIN 22118 which are not fitted with a master cylinder. Fits:  1975-1980  (VIN 22118-41686)  

This is the caliper gallery seal, which is needed if you plan on breaking apart the actual caliper when rebuilding.  This seal fits in between the two halves.  Early front calipers (for non-vented / solid brake discs) have one gallery seal...

These pins are required when replacing the front brake pads CD6722 (pre 1973 cars). 2 pins required per caliper so 8 required per axle. The R clip for the end of the pins is CD4076. The pins are also fitted into the rear calipers but are supplied as...

This is the dust cover for the bleeder screw.   These are for bleed screw UR10967 Note: Sold Each All Models  

This is the short bleed nipple suitable for all Silver Cloud/ S Type wheel cylinders, all Silver Shadow, T-series, and Silver Wraith Type rear calipers and accumulator valve bodies. Early Silver Shadow models with solid front brake discs were originally...