Brake Pumps and Push Rods

This is the high pressure pipe between the rear brake pump and the rear accumulator.  1973-1980: Rolls-Royce Camargue (14674-26708) & Corniche (12346-35878) Phantom, Silver Shadow II Saloon (30001-41601) Silver Shadow Saloon...

This is the main internal spring of the brake pump. 1966-1980  Silver Shadow, T-series, Shadow II, T-2, Silver Wraith II 1980-1998  Silver Spirit, Silver Spur, Mulsanne, Turbo R Pre Arnage 

This is the inlet valve spring for the brake pump. 1966-1980 Silver Shadow I, II & Bentley T1, T2

This little O ring/seal fits several different parts on your car.(Brakes, Flagstaff, Accumulator, fuel system, air condition) Please inquire with our staff for specific use or reference attached diagrams.  1966-1980  Silver Shadow, T-series,...

 This is a brake pump seal kit for the RR363 systems. You will need to remove the pump from the car in order to re-seal it. ***We sell or loan out the tool (RH8428) that will allow the pump to be removed in suit without having to strip down the top...

This is the brake pump removal tool. If the inlet and outlet pipes are removed from the brake pump and the top circlip is removed then the housing of the pump can be removed. This tool goes over the pump in place of the housing and the castellated teeth...

This is the brake push rod.  It is 11cm long and it was originally part number UE36794 There were three different lengths of push rod fitted to cars between 1966 and 1980. This is the last type fitted. It measures 11cm in length. If you require a...

This is the brake pump housing often found broken or corroded. 1966-1980  Silver Shadow, T-series, Shadow II, T-2, Silver Wraith II           

Brake Pump Feed Pipe o ring.  This is the o ring that seals the brake pump feed pipe to the inlet on the housing of the brake pump.  Cars before vin# 6644 will not have this o ring. It also has a number of applications including for the...

This is a good used brake pump cam follower.  This is what the brake pump push rod sits on. The original Rolls part # was UE36857 1966-1980 Silver Shadow I,II,III, T-series, Silver Wraith II 1981-1998 Silver Spirit, Silver Spur, Mulsanne,...

This is the brake pump cam follower. This is what the brake pump push rod sits on. The original Rolls part # was UE36857 1966-1980 Silver Shadow I,II,III, T-series, Silver Wraith II 1981-1998 Silver Spirit, Silver Spur, Mulsanne, Turbo...

This is one of the two sealing rings that sit between the brake pump and its housing. There are two O rings per pump and they come as part of the main brake pump seal kit (RH2438). To replace these O rings you do not need to remove the pump from the car...

This is a fully reconditioned brake pump, ready to install.  All of our reconditioned hydraulic units for cars from 1966-1980 are rig-tested prior to dispatch. This part comes with a full 12 month guarantee. Early models prior to 1972 approximately...

This is a fully reconditioned brake pump with a 3/4" (inch) union on the end of the high pressure pipe that fits to the top of the brake pump. All of our reconditioned hydraulic units for cars from 1966 - 1980 are rig-tested prior to dispatch. This part...