Hood (Bonnet) and Fittings

This 2BA x .375in long Screw fits: Phantom V - Headlamp Retaining Rim & 4 Speed Transmission Oil Cooler Cloud III & S3 - Headlamp Retaining Rim 1966-1980 Throttle Linkage Pedal RHD, Under Bonnet...

This washer is found all over the cars from 1955-1997 Front Door Hinge Transmission Gear Change Volute Casing Thermostat

Rear Hood Seal (the one closest to the windshield under the hood) 1966-1980 Shadow, Shadow II, T-series, T-2, Corniche Coupe & Corniche Convertible 1981-1998 Corniche, Eight, Mulsanne, Spirit, Spur &...

This is the hood/bonnet chrome retaining bolt for the moulding strip. 1966-1980 Silver Shadow, T-series, Shadow II, T-2, Silver Wraith II

This is the Male hood chrome retainer.     Note: 6 required per car (Sold Each) 1966-1980 All Models 1982-1986 Corniche (VIN 05037-16968) 1985-1987 Continental (

This is the hard seal that pushes onto the internal lip of both the bonnet (hood) and boot (trunk).  Sold per foot.  The lengths required are below: Shadow 1 bonnet 1.4 metres = 4.593"Shadow 2...

.125UNF x 1.250 long Bolt has many areas found on the car.  Cloud I & S1 - Exhaust Manifold to Downpipe (3 bolts per manifold); Center, Front Silencer & Tail Pipe Silencer (6 bolts) & 12 bolts...

These are the rubber grommet for the two hood catch mechanisms.  These grommets sit in the radiator grille shell mounts. Note: 2 Per hood catch (Sold Each) 1966-1980  Silver Shadow, T-series,...

This .250UNF x .625in long Bolt fits: Note: Contact us for direct diagram fitting to the areas listed below 1955-1965  Power Steering Cylinder Bracket, A/C Controls & Demister Ducting Blower, A Bank...